I have a small round dodgy LED light in the step well of my Jurgens. I can get the fascia and lens off but that's it. Do I have too break it to get it out or is there a way of getting it out without breaking it. Tried turning it and also levering it with a screw driver. No luck at this point.
boab said
12:05 PM Dec 21, 2017
Rusty, jurgens have a face book page if you ask the same question there i am pretty sure you will get an answer
madaboutled said
01:12 PM Dec 22, 2017
A lot of new LED fittings are sealed, as such designed for complete replacement. A picture might help to identify how to open it if its possible.
Tony Bev said
09:59 PM Dec 22, 2017
Assuming that most under the step lights are more or less the same
Can you let us all know how you removed it, Rusty
I tried to remove mine on a Jayco Conquest to change what I think is a normal globe, to a LED one
Did not have much luck, and stopped before I broke it
RustyD said
07:43 PM Dec 23, 2017
Just scripted a letter to Jurgens for sending in the New Year after lots of testing yesterday.
Like a lot of people on this forum, what I'd really like is the 12v wiring diagram for my van. I have 12v across the switch for the outside LED globe but only 3.5v across the switch for the stepwell globe even though they have a common (jumped) +ve connection (2 gang switch). The stepwell globe is causing my 12v regulator (Omegalec) to trip and I have to power it off & on again. Suspect that the LED globe is not good so crushing it to remove it may be necessary. Also not sure if it's a globe in a housing or it's all one unit. That's a question I have for Jurgens.
Aus-Kiwi said
11:18 PM Dec 23, 2017
Can you disconnect the wires to it ? Yes ours is sealed donāt think same brand ?
RustyD said
07:04 PM Dec 25, 2017
Aus-Kiwi wrote:
Can you disconnect the wires to it ? Yes ours is sealed donāt think same brand ?
Cant disconnect and no idea what brand. That is actually my problem. Ill try Jurgens in the New Year.
I have a small round dodgy LED light in the step well of my Jurgens. I can get the fascia and lens off but that's it. Do I have too break it to get it out or is there a way of getting it out without breaking it. Tried turning it and also levering it with a screw driver. No luck at this point.
A lot of new LED fittings are sealed, as such designed for complete replacement. A picture might help to identify how to open it if its possible.
Can you let us all know how you removed it, Rusty
I tried to remove mine on a Jayco Conquest to change what I think is a normal globe, to a LED one
Did not have much luck, and stopped before I broke it
Like a lot of people on this forum, what I'd really like is the 12v wiring diagram for my van. I have 12v across the switch for the outside LED globe but only 3.5v across the switch for the stepwell globe even though they have a common (jumped) +ve connection (2 gang switch). The stepwell globe is causing my 12v regulator (Omegalec) to trip and I have to power it off & on again. Suspect that the LED globe is not good so crushing it to remove it may be necessary. Also not sure if it's a globe in a housing or it's all one unit. That's a question I have for Jurgens.
Cant disconnect and no idea what brand. That is actually my problem. Ill try Jurgens in the New Year.