I'm about to change brake magnets on the Van both sides as one has worn to it's limit wear mark. Not sure how to remove the magnet retaining clip (In center of magnet) any advice appreciated.
Regards.
Outback.
darjak said
01:08 PM Dec 18, 2018
Push magnet inwards and I usually just use a small screw driver
to unclip it. When redoing wires for magnets I always solder them
together and use heat shrink, don't like cable joiners.
Darjak
Hetho said
05:15 PM Dec 18, 2018
Hi Outback
If you do a google search on "Alko magnet replacement" you will find a video on how to replace them.
To watch the video is easier than us all putting it into words.
Regards.
Hetho
Outback said
06:37 PM Dec 18, 2018
Thanks Darjak
I intended to solder and shrink wrap.
Outback said
06:42 PM Dec 18, 2018
Thanks Hetho
looked at a lot of videos must have missed it will have another look.
Kind regards
Outback
herks said
07:35 PM Dec 18, 2018
Be aware that there is a difference between "On Road" and "Off Road' magnets, Get the correct ones for your setup.
Hi All
I'm about to change brake magnets on the Van both sides as one has worn to it's limit wear mark. Not sure how to remove the magnet retaining clip (In center of magnet) any advice appreciated.
Regards.
Outback.
to unclip it. When redoing wires for magnets I always solder them
together and use heat shrink, don't like cable joiners.
Darjak
Hi Outback
If you do a google search on "Alko magnet replacement" you will find a video on how to replace them.
To watch the video is easier than us all putting it into words.
Regards.
Hetho
Thanks Darjak
I intended to solder and shrink wrap.
Thanks Hetho
looked at a lot of videos must have missed it will have another look.
Kind regards
Outback