We are in Sandstone WA.Our water pump switch on our Drifter house Monitor is Stuffed on our maiden trip.
The pump will work only if I hold the hardest plugs X 2 at the rear in the cuboard in our Jayco Journey Outback.
I need to remove the unit total to try and fix the 2 clip in plugs behind.
I cannot see any screws holding it in from the rear. Can anyone tell me if the face clips off, or can the unit pull straight out from the front as it too is loose to the veneer timber surface.
Insert flat-blade screwdriver into slot 'A'. Gently lever case away from bracket enough for dimples 'B' to clear locating holes Then slide Drifter upwards. Note: Some force may be needed to slide the Drifter upwards because it usually binds tightly on the four locating tangs
-- Edited by iana on Sunday 4th of September 2016 11:38:12 PM
I wouldn't go plastering blue tack back there, what is actually wrong. The switch on my unit also went u/s, but the switch itself wouldn't operate, and was permanently on.
Those plugs going into the rear of the unit fit pretty well, maybe the loom is putting weight on it, the loom may need supporting.
