I am going to install a new MPPT controller and the recommendation is to change from parallel to series.
From the pwm picture the positive and negative leads from two panels are wired into the same ports on the controller, to make it series do I join one +ve to -ve ( in an isolated block) and then wire the other +ve and -ve into the respective ports on the new controller?
Yes you are correct about the wiring for series connection.
You do not have to do that however, you could just wire them up in parallel as you have done the other controller. There will be no difference in output IMHO in your case. I assume you have normal 12V panels with a VMP about 17-18V.
Thanks, I was told more that a series connection would be more efficient as a higher voltage lower amperage would result in less loss in the cables and more amps to the batteries
If this is marginal, I will just replace like for like
Thanks, I was told more that a series connection would be more efficient as a higher voltage lower amperage would result in less loss in the cables and more amps to the batteries
If this is marginal, I will just replace like for like
Cheers
Les
Hi Les
What was said can be correct if the wires are connected in series close to the panels so the current is reduced in the wiring going down to the controller. But in your case they are just connected at the controller anyway so no difference in losses.
I assume your controller will be close to the battery as it should be. To get the most benefit from a MPPT controller the wiring size from the panels should be generous too.
I have installed as a straight replacement, moving the controller and changing cable rating and run are both a pain, I will see how the new set operates on a day to day basis before ripping cabling out of the van
Les. Jaahn has explained that there will be no advantage in the way of power loss for series connection. There is also another thing to consider and that is panel shading. If you are running a series string, if one panel gets shaded your array will nearly close down. If you have the panels in parallel and one gets shaded, the other panel will still operate at full capacity. Your charging will thus be better with the parallel panels.
__________________
PeterD Nissan Navara D23 diesel auto, Spaceland pop-top Retired radio and electronics technician. NSW Central Coast.
Series has a number of advantages that are discussed in detail by others elsewhere.
Series becomes important when you get to large arrays. We have 1410 W of panels and have gotten over 1400 W into controller when camped at 3.5 km, sunny days, in June.
This is 117 amps at 12 V but only 16 amps at 90 V and 29 amps at the 48 V nominal of the LFP battery suite. We have a 45 amp MTTP controller and thus have 50% over capability
Short distance as in caravan etc there's not much gain ! In a house situation ? Distances can be longer so is the load and output. parallel can be multy cables to regulator .. Or run in groups .. We are running a low wattage system compared to home solar .. 400 watt is enough for most system with 2 or 3 batteries . Or should I say 2 or 300AH ... 50% more than required so there's less drain on batteries ..
www.youtube.com/watch [ actual reality no bs] proof in a small well designed system [same panels ] system ,series vs parallel makes little difference .
All
Thanks for the advice, wired in parallel and been off grid for 7 days. Batteries (2 x 120 AGM Deep cycle) go to float around lunch off 300 Watts of panel
Cheers