check out the new remote control Jockey Wheel SmartBar Topargee products Enginesaver Low Water Alarms
Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: Lights flickering


Guru

Status: Offline
Posts: 743
Date:
Lights flickering


Hi all

First up

After some advise please, when we turn our diesel heater on start up, all lights on at the time flicker badly, to the point they need to be turned off for about 30secs, then things are back to normal. Then when heater is on, warming nicely, lights flick, just the once, in line with the tick noise which is the diesel pump.

Second

When the water pump is on, slowly and slightly pulsating as they sometimes do when not on full, again any lights on flicker, not bad but noticeable.

All lights are the led type on a new van.

Also batteries x 2 fully charged

any suggestions appreciated

Ian



__________________


Guru

Status: Offline
Posts: 879
Date:

Same problem. When the water pump is running the LEDs flicker if all is running on battery. Been trying to solve this as it's rather annoying.

Start-up on the diesel heater may draw a bit more current that when it settles down.

Our A/C running via generator does similar on startup. Lots of startup current then settles down. Will trip the circuit breaker on the generator on cold sometimes. Have to turn everything off to start then once going we can turn everything else back on.

__________________

Centrelink - Living the Dream.



Guru

Status: Offline
Posts: 743
Date:

Thanks Rusty
Nice to know I'm not the only one having problem, lets see what else comes in to help us
cheers
Ian

__________________


Guru

Status: Offline
Posts: 7642
Date:

Check wire size and connections . Check voltage at battery? Then at lights and heater while operating . Both connections + and earth - ..

__________________
Whats out there


Guru

Status: Offline
Posts: 2689
Date:

Is the diesel heater wired direct to the batteries as per installation instructions ?

__________________
Bill B


Guru

Status: Offline
Posts: 4730
Date:

Sounds like a wiring problem. Somewhere in the circuit all your power is travelling down a common wire. That length of wire could be too thin or have a bad join in it. When the extra power is being drawn by the heater or pump the extra current causes an increase in voltage drop. As suggested above, relocate the wires to the heater so they are connected straight to the battery.

The other thing could be crook batteries. Does the problem happen when the battery charger is operating or only when there is no mains power connected to the battery?

__________________

PeterD
Nissan Navara D23 diesel auto, Spaceland pop-top
Retired radio and electronics technician.
NSW Central Coast.

 



Guru

Status: Offline
Posts: 743
Date:

Thanks for ALL replies, stuck for time at the moment but will decipher soon and get back to all
regards
Ian

__________________


Member

Status: Offline
Posts: 11
Date:

PeterD wrote:

Sounds like a wiring problem. Somewhere in the circuit all your power is travelling down a common wire. That length of wire could be too thin or have a bad join in it. When the extra power is being drawn by the heater or pump the extra current causes an increase in voltage drop. As suggested above, relocate the wires to the heater so they are connected straight to the battery.

The other thing could be crook batteries. Does the problem happen when the battery charger is operating or only when there is no mains power connected to the battery?


 QFT

 

Pumps 'n' heaters aren't the most power friendly, run dedicated wires from your bus bar to them and back.



__________________


Guru

Status: Offline
Posts: 7642
Date:

Bad earths also if lights are wired that way ?

__________________
Whats out there
Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.

Tweet this page Post to Digg Post to Del.icio.us
Purchase Grey Nomad bumper stickers Read our daily column, the Nomad News The Grey Nomad's Guidebook