check out the new remote control Jockey Wheel SmartBar Canegrowers rearview170 Cobb Grill Skid Row Recovery Gear
Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: Ideas to fix awning please


Guru

Status: Offline
Posts: 4706
Date:
Ideas to fix awning please


It's too hard to describe so I'll simply say "See the photograph."

Suggestions please for getting the thingie (what's it called?) back into the roller and, ideally, keeping it there. In the past slackening the awning and using a pair of pliers to move it 3 or 4mm at a time has partly worked but it seems to work its way out again. Ideas guys?

 

Awning.jpg



Attachments
__________________

 

"I beseech you in the bowels of Christ think it possible you may be mistaken"

Oliver Cromwell, 3rd August 1650 - in a letter to the General Assembly of the Kirk of Scotland



Senior Member

Status: Offline
Posts: 345
Date:

Mike,

My awning has a small screw to secure the rope into the sail groove.

Mine was doing the same or similar thing and the dealer did the fitting of the screw so I am to assume it might be a common fix.

My awning did it when I was staying in one spot for a while and the prevailing wind seemed to help it move towards one end.
As I pulled mine back toward the correct spot I would roll the awning up and down which seem to free up the rope bit and after each roll it moved a bit easier.

I am not that good with mechanical things but that is what my dealer advised me until I could return the van to him.
Short overnight stops didnt seem to cause a problem.






-- Edited by RickJ on Saturday 21st of January 2023 02:54:07 PM

__________________

Don't sell the Sun to buy the Candle



Guru

Status: Offline
Posts: 8493
Date:

Mike, is the beading coming out of awning eye? If so, slacken the vinyl, push it back in after cleaning with metho, squeeze in some rubber glue (Kwik Grip).

Also purchase or make awning tie-down clips www.ebay.com.au/itm/154863554793
Tying down on roller axle not a recommended practice.


__________________

Possum; AKA:- Ali El-Aziz Mohamed Gundawiathan

Sent from my imperial66 typewriter using carrier pigeon, message sticks and smoke signals.



Senior Member

Status: Offline
Posts: 468
Date:

That is called the spline or some use the term piping.  Generally it is stitched at the ends of the awning to stop it coming out and as suggested a small screw placed at the end to stop the awning sliding.

Those clips suggested by Possum are great.  Hope you use screw pegs too. smile



__________________


Guru

Status: Offline
Posts: 1133
Date:

Hi Mike,

Possum has picked up on something that I was about to. Using the roller spindle to tie down is not a good idea. The spindle is the weakest part of the roller and if it gets bent out of whack the chances are that you could be stuck with an awning that will not rollup.

I always put the tie down round the main support arm. I was given this tip many moons ago by a dealer in WA.

 



__________________

It is what it is, but it aint what it used to be.

 



Guru

Status: Offline
Posts: 4706
Date:

Thanks for you inputs people, much appreciated.

Possum: very good tip thank you, clips are on order.



__________________

 

"I beseech you in the bowels of Christ think it possible you may be mistaken"

Oliver Cromwell, 3rd August 1650 - in a letter to the General Assembly of the Kirk of Scotland



Guru

Status: Offline
Posts: 7314
Date:

I bought rope from Whitworth Marine to replace all the rubbish supplied with our awning, like every awning.

 

Two very useful knots are:

Tautline knot,

Truckers knot (which can be doubled up for 1:4 ratio).

 

Not to forget the Bowline knot.



__________________

Procrastination, mankind's greatest labour saving device!

50L custom fuel rack 6x20W 100/20mppt 4x26Ah gel 28L super insulated fridge TPMS 3 ARB compressors heatsink fan cooled 4L tank aftercooler Air/water OCD cleaning 4 stage car acoustic insulation.



Guru

Status: Online
Posts: 767
Date:

Tried the circlips suggested by Possum3 but didn't like them - I found that they actually rotated the roller just enough to put slack in the awning.

Instead I replaced the screws holding the cap onto the top of the main support arm with 8mm stainless steel lifting eye NUTS secured with 8mm stainless steel screws.

Then use snap spring hook carabiners, also 8mm stainless steel on the guy ropes. When pegging down the awning the carabiners are simply snapped onto the ring eyes, then on packing up the carabiners are unsnapped - no knots to untie.

I know that there are cheap carabiners on the market that would be unsuitable to the job, but the 8mm S/S ones are pretty strong - in fact, the ones I bought are rated for mountain climbing.

Having the lifting eye on top of the main support arm no pressure is placed on roller spindle as noted by Magnarc.

Now, back to the original topic! Like Riki1 the spline in our awning roller is held in place by a small self-tapper screw. It has never moved since we have had the van.

Murray

PS: - lifting eyes come in two types, nut or bolt. The bolt has a screw for fastening with a nut, although mostly the screws are generally short. Whereas the nut has to be fixed with a bolt or screw of a length suitable for the job.




__________________

Retired - A Long Weekend Lasts All Year



Veteran Member

Status: Offline
Posts: 45
Date:

Move the rope into position, drill small pilot hole, fit self tapping screw.  Done.

sail track stop screw.png

bye.



Attachments
__________________

Bruce & Judy pulling a 3T 23.5' Traveller Prodigy behind a Diesel Range Rover



Senior Member

Status: Offline
Posts: 436
Date:

Not sure about your problem but I was told years ago NOT to put guy ropes on the awning rod as yours is!!

Dick.



__________________


Guru

Status: Offline
Posts: 1840
Date:

One of these on each arm.

product-image



__________________


Guru

Status: Offline
Posts: 5378
Date:

A few years ago, I assisted Dick0 (Richard), to put a new canvas on Fays caravan awning

The spline rope had a small screw, which went through the rope into the roller, as bruceg has pointed out

__________________

Tony

It cost nothing to be polite

Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.

Tweet this page Post to Digg Post to Del.icio.us
Purchase Grey Nomad bumper stickers Read our daily column, the Nomad News The Grey Nomad's Guidebook