My current power is 2 X 200 watt panels fixed to top and side of trailor. I am about to replace my two AGMs with 2 new ones. They were installed In 2019 so I am very happy with them. New ones will be same make.did originally have lithium but after 18 months nfg. Going AGMs as I can replace them myself, they will work and when in bush I won't have to travel and try and get them fixed under warranty unlike some lithiums.
Yep if I had the dosh I would get top of line lithiums.
My usage is Engel running 24x7 off 1500 watt inverter
when lots of sun I run it as a freezer and make ice coke bottles to put on my Evakool Esky. I also charge phones, laptop,fan, USB light,toaster, sandwich press and sometimes induction cooler but mainly if battery fullish and usually in total fire ban.
They charge via a projecta which can draw from solar or dcdc from car when motor runs.
How do I add the solar blanket 400 watt to the array. Can I direct to battery when I use them, will it overload battery? Or do I have to send it via the projecta, which would be cutting and splicing wires I suspect.
Hopefully I can just connect to battery. Solar blanket has its own mppt.
I also want to add a monitor to setup so I can visually see input, draw and status amps and volts etc I have seen a few.....any recommendations?
Cheers.
Getting ready the journey continues soon.......
I only have 6 x 20 watt panels (custom built portable set-up), so I can & did quite a bit of slice & divide tests. Series & parallel.
I also have 2 Victron Bluetooth MPPT controllers, 10/75 & 20/100. But I only need one. The other is a spare.
Out of interest I plugged 40 watts into the small one & 80 watts into the larger one. Then both to the 4 x 26AH batteries.
I didn't do any fine tuning of the controllers' voltage via Bluetooth.
So initially they both charged the batteries together. But eventually it turned out that the larger controller thought the batteries had enough voltage and stopped charging. But the batteries were fairly well charged. Because it would have been a slightly higher voltage setup for the smaller controller.
Whether the voltage figure on the display was a bit higher or simply a tolerance variation I don't know as I didn't check.
So one would need to set up the priority of which one you would prefer to stop charging first by setting the main one to a whisker higher voltage.
No point having the smaller solar array taking over.
__________________
Procrastination, mankind's greatest labour saving device!
50L custom fuel rack 6x20W 100/20mppt 4x26Ah gel 28L super insulated fridge TPMS 3 ARB compressors heatsink fan cooled 4L tank aftercooler Air/water OCD cleaning 4 stage car acoustic insulation.
Yes you can connect the solar blanket MPPT directly to the battery. It will work best if the MPPT controller is close to the battery, rather than mounted on the solar.
Each controller will do what it is set to do (check that they are suitable for the batteries). They will not overload the battery if set correctly.
A monitor will need a shunt to give you the info you seek. That shunt needs to be close to the battery and the inputs and outputs for the loads and solar connected to the other side from the battery. Victron is a good way to go for both the shunt and the monitor.
Why are you running the Engel from an inverter? That would seem to be a waste of power. They are designed to run from 12V directly.
Cheers,
Peter
