there have been a few posts about waeco problems but i am a bit stuck despite all the good advice (thanks debe)
cf 50 that runs fine on 240 and stops at desired temp. runs when emergency switch is activated. runs when bridging c and t as you suggested to try but does not start with 12v .
the temp display works and the power light is orange. the board is a 101n500 and i measured 13 v on the input and 13v on the other board on the rightest pin on the incoming plug (if that makes sense).
is there anything i can try to isolate the problem ? (obviously ringing or trying to get in contact with waeco is impossible)
